CipherLab 1266 Podręcznik Użytkownika Pobierz pdf (Strona 28)

ScanManager User Guide

1.4 READ NEGATIVE BARCODE

Normally, barcodes are printed with the color of the bars darker than that of the spaces.

But for negative barcodes, they are printed in the opposite sense just like negative films.

The spaces of negative barcodes are printed with a color darker than that of the bars. You

can configure the scanner to be able to read negative barcodes.

1.5 AUTO SENSE (1100 ONLY)

This mode is only available when you want to seat the scanner in the Auto-Sense Stand.

When you enable this mode, it will force the scanner to apply Laser mode as the scan

mode. However, it works slightly different from the original Laser mode. Now the scanner

will be scanning as long as it is seated in the stand. Whenever a barcode is brought

within range, the scanner will be able to decode it.

Note: Auto-sense can only be enabled for CCD scanner and will force it to Laser mode.

1.6 MEMORY MODE (1160, 1166, 1260, 1266)

By default, memory mode is disabled. When the scanner is set to memory mode, it

means a WPAN connection is disabled. You may set a delay between each data record

while transmitting data back to the server.

 The cordless scanner keeps 128 KB flash memory for memory mode operation.

1.7 TRANSMIT BUFFER (1166, 1266)

By default, transmit buffer is disabled. You may enable it for use when the scanner is out

of range. Upon reading a barcode successfully within range, the scanner responds with

one short beep (high tone) and its LED indicator becomes solid red and goes off quickly.

However, the host computer may not receive the data immediately if getting out of

range.

 The cordless scanner keeps 4 KB transmit buffer. It can ignore the transmission

status and keep on reading barcodes until the buffer is full.

Note: For 1160 or 1260, it will not be able to scan when out of range.

Transmit Buffer Enabled

 When transmit buffer is enabled and the scanner is out of range, the scanner will respond with

two short beeps, high-low tone, upon reading a barcode successfully.

 When transmit buffer is full, the scanner will respond with one long beep (low tone) and its

LED indicator will become solid red and go off quickly. You are advised to get back to range.

Transmit Buffer Disabled

 When transmit buffer is disabled and the scanner is out of range, the scanner will respond

with one long beep (low tone). You are advised to get back to range.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 91 92

Brak uwag

CipherLab 1266 Podręcznik Użytkownika Strona 28