CipherLab 1562 Podręcznik Użytkownika Pobierz pdf (Strona 22)

ScanMaster User Guide

Multi-Barcode Mode

The scanner will be scanning as long as the trigger is held down, capable of decoding not only one

single barcode but a concatenation of unique barcodes.

 The scanning won't stop until you release the trigger.

Note: (1) A barcode is considered unique when its Code Type or data is different from

others. (2) Multi-Barcode Mode has nothing to do with the Multi-Barcode Editor.

Alternate Mode

The scanner will start scanning once the trigger is pressed.

 The scanning won't stop until you press the trigger again.

1.1.1 SCANNING TIMEOUT

Specify the scanning time interval (1~254 sec.; 0= disable) when the scan mode is set to

any of the following –

 Laser mode

 Auto Off mode

 Auto Power Off mode

 Aiming mode

1.1.2 CONTINUOUS MODE DECODE DELAY

Set the time interval between each decoding when in Continuous Mode.

1.1.3 AIMING TIMEOUT

You can limit the aiming time interval (1~15 sec.) when in Aiming Mode. By default, the

scanner time-out is set to 1 second.

1.1.4 RE-READ DELAY

This is also referred to as the “Blocking Time”, which is used to prevent the scanner from

accidentally reading the same barcode twice when the scan mode is set to any of the

following —

 Continuous mode

 Auto Power Off mode

 Alternate mode

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 81 82

Brak uwag

CipherLab 1562 Podręcznik Użytkownika Strona 22